Auto Cable ID numbering...

By default, ElectrcialOM creates cable IDs as follows:

  • For distribution cables: c-d-#
  • For final circuit cables: c-f-#

The user can set a specific way of ID creation using the Auto Cable ID numbering... menu. Distribution circuit cable and final circuit cable numbering rules can be defined independently. If Enable box next to each title is checked , then, the rule defined will be applied to the related type of circuit cables within the project. If it is unchecked, then, ElectrcialOM will still use default numbering system. User can preview the cable ID created by the rules defined under Sample section.



Auto BTS sections numbering...

By default, ElectrcialOM creates BTS section IDs as Section 1, Section 2, etc, but the user can set a specific way of ID creation using the Auto BTS sections numbering... menu. The rule defined will be applied to the selected BTS. There are two BTS below.  User selects the one on the left hand side and defines a rule for auto numbering sections.





BTS sections connected to the selected BTS box are renumbered where the sections connected to the BTS box on the right are not affected.