Recent Posts

Pages: [1] 2 3 ... 10
1
Calculations & Checks / Re: Selectivity/Discrimination
« Last post by Unknown on 15 May 2024, 08:56 »
Hi

thanks for the reply.

I've had a play around with the options shown in the screenshots but I still can't get the software to warn me when I'm not achieving full selectivity.

Can you show me an example of the software warning that total selectivity is not achieved?
2
Calculations & Checks / Re: Selectivity/Discrimination
« Last post by admin on 14 May 2024, 08:39 »
Hi,

Please see some screenshots below that might help





3
Calculations & Checks / Selectivity/Discrimination
« Last post by Unknown on 07 May 2024, 08:17 »
Hi Mert

thanks for the reply.

I've had a look above the selectivity area as you have suggested and I can't find any buttons that might hide selectivity.

I've also looked at the calculation options under "Project info and options" but couldn't see anything relating to hiding selectivity.

Would you be able to provide screenshots of where these buttons are?

thanks.
4
Calculations & Checks / Re: Selectivity/Discrimination
« Last post by Mert on 06 May 2024, 07:38 »
There are various reasons, and one of them is hiding selectivity warnings. Check the buttons above the selectivity area and make sure selectivity is not hidden.
5
Calculations & Checks / Selectivity/Discrimination
« Last post by Unknown on 03 May 2024, 14:36 »
I've been looking at the selectivity tables in the program and I've found that I'm not getting warnings when I don't achieve full selectivity.

Is there an option somewhere I need to enable for this to happen?
6
Calculations & Checks / Containment calculator
« Last post by toddwebb on 15 March 2024, 10:58 »
A good addition to the software would be a containment calculator for sizing multiple containment types

Having options and reports to show calculations to BS8519 Annex E guidance, would be a handy feature. Especially with the Building safety act being implemented.

I appreciate this would be some investment.
7
Hello,

Thank you for the feedback. We have adjusted this and the sheath will be considered too. Please see the example below:

8
I passed this to dev team. They will look into this.
9
ElectricalOM for Advanced Users / Re: Distribution Board Schedule information
« Last post by Mert on 20 February 2024, 06:50 »
Hi,

Incomer device is defined using the subordinate tab, Incomer, of Protective Devices tab of Circuit Edit module, and this will be displayed on the Boards Schedule.

You can define the rest using Other tab of Circuit Edit, however, these will not be shown on the report. We  may add those to the report as per your request in coming updates.
10
ElectricalOM for Advanced Users / Distribution Board Schedule information
« Last post by toddwebb on 19 February 2024, 13:56 »
How do you include the following information onto distribution board schedules when automatically generating it?

Incoming device / rating
Busbar rating of the board
Form and IP Rating
Pages: [1] 2 3 ... 10