ElectricalOM Support > ElectricalOM for New Users

Measuring a known distance

(1/1)

Ronniechew:
Hello,

Is there a way of measuring a known distance? So say if I wanted to place two lights 1.2 m apart on an already scaled drawing, how would I do that, I know I can measure using the measuring tool between two fixed points but not sure about the former. 

Thank you

Mert:
its like normal cad. copy the symbol move the mouse to the direction, type the distance in metres and press enter. Or draw a line as a guide and the osnap to the end of the line

Ronniechew:
Hi I have never used normal CAD. Where do I type the required distance? Equally when I draw a line how do I know the distance of that line?

admin:
Hi,

When coping in cad you can move your mouse to point to a direction and then type a distance that will denote the length to copy the figure. The action submits by pressing enter and ends with mouse right-click or by pressing escape.

Similarly, when drawing a line you can set the start point and then move the mouse right, for example, and type the length you want the endpoint to be located from the starting point.  Again the action submits by pressing enter and ends with mouse right-click or by pressing escape.

You can always review the action progress at the command area.

Also, the ortho mode helps be on a straight line.

See the video here that will help:  https://nextcloud.com.gr/modecsoft/index.php/s/Frd79fZPGywqgs9

Navigation

[0] Message Index