ElectricalOM Forum

ElectricalOM Support => ElectricalOM for Advanced Users => Topic started by: mbd-uk on 10 December 2023, 16:25

Title: Surge Protection Kit
Post by: mbd-uk on 10 December 2023, 16:25

Where the supplier provides surge protection as a kit, is it possible to install the SPD as a direct connection, without using a way number.
This application is a single phsase consumer unit

Title: Re: Surge Protection Kit
Post by: Mert on 11 December 2023, 05:23

Hi,

You can try to select the board you want the SPD protect, and navigate to Protective Devices tab of the Circuit Editor. You will see subordinate tabs one of them is Surge protection. You can tick the Use SPD at Incomer box and this will insert an SPD at the incomer side of the selected board.

Regards.


(https://i.postimg.cc/pm4M0vWC/SPD.png) (https://postimg.cc/pm4M0vWC)