We've had feedback from some clients regarding how we show split load consumer units with the extension board. Generally it's found to be confusing with the split section having a prefix of the way it was added to, e.g. by adding the extension board to way 9, all ways then become 9.1, 9.2, 9.3 etc.
Is there any way to avoid this and just start the numbering again?
We also are struggling with how RCD protective devices are shown for split load consumer units. Below are two screenshots. One using ElecOM and one using a different software package. I'd like to try and make the ElecOM output more like the other image as it's easier to understand. Does anyone know any better ways of setting up the reports?